Top: Constructed of 18 gauge, type 304 stainless steel, die stamped with a raised perimeter bead. There shall be a solid vinyl gasket under the beaded edge to form a seal to the counter top, thus preventing seepage or marring of the counter top. Embossed mounting lugs are provided along the inner surface of the top to hold a full set of removable separator channels in place.
Liner: The inner liner shall be 18 gauge, type 304 stainless steel, one piece construction, all welded, ground and polished to a uniform finish. All corners are coved with a minimum 1/4″ radius. A 3/4″ dia. drain with strainer, 4″ PVC nipple, and valve is provided.
Insulation: The pan is fully insulated with high density polystyrene, 1″ thick on all sides, 2″ thick on the bottom and enclosed with a 22 gauge galvanized steel outer case.
Refrigeration System: The compressor housing shall be fabricated from 14 gauge galvanized and bolted to the base of the unit. A fully self-contained condensing unit is provided with a hermetically sealed compressor and a thermostat control. The system is also provided with a forced air evaporator for even temperature throughout the pan that drains into a condensate evaporator pre-wired in the unit. Automatic defrost system is provided. The system is fully charged with CFC-free refrigerant and ready to operate.
Note: Proper ventilation must be provided in counter.
Electrical: The unit will be wired for 15 amp, 120 volt, single phase operation with an on/off thermostat switch and pilot light. A 6′-long, 3-wire cord and plug (NEMA 5-15P) will be provided.
