Top: Constructed of 16 gauge, type 304 stainless steel, die-formed, welded, ground and polished. The top is provided with an opening to receive the appropriately sized drop-in unit.
Body: Frame construction shall be of hi-tensile stainless steel square tub-ing, 1-1/4″ x 1-1/4″. Frame sections are welded construction, ground and pol-ished to a uniform finish. Body & panel is constructed from 18 gauge stainless steel with 1/16” thick plastic laminate Front & ends. rear aprons is constructed fron 16 gauge stainless steel with 1/16” thick plastic laminate fin-ish. Owner to specify finish. An integral locking device shall be provided to align and retain cart positioning when two or more carts are joined.
Refrigerated Frost Top: The cart includes a WF series built-in refrigerated frost top installed in the top. Constructed of 18 gauge, type 304 stainless steel, with a raised perimeter bead and solid vinyl gasket. The frost top (plate) is 14 gauge stainless steel with copper tubing firmly soldered to the exterior bottom. The unit is fully insulated with high density fiberglass and polystyrene, 1-1/2” thick, and enclosed with an 18 gauge galvanized steel outer case. The top stands 1” above the counter top and is surrounded by a 1/2” full perimeter gutter to collect melted condensate. A 1” IPS drain is provided.
Refrigerated Base: RB Series: Double wall constructed with a 20 gauge, type 304 stainless steel interior liner, with coved corners. Cart body forms the exterior of the base with an 18 gauge stainless steel fascia on operator’s side. The unit is insulated with 1″ of high density polystyrene on all sides. The interior is provided with a slide assembly to accommodate 12″ x 20″ pans. A 2-1/2″ dial thermometer is mounted in the fascia. Doors are double wall constructed of 18 gauge, type 304 stainless steel, fully insulated with high density polyurethane and provided with edge mounted, chrome plated hinges and a slam action latch. Doors are complete with a moisture-proof gasket.
Refrigeration System: Two (2 ea.) fully self-contained condensing units are provided, one integral with the frost top, the other integral with the refrigerated base, each with a hermetically sealed compressor and a thermostat control. The refrigerated base is also provided with a forced air evaporator which drains into a condensate evaporator. The systems are fully charged and ready to operate. Two (2 ea.) removable louvered access panels are provided.
Electrical: The unit will be wired for 15 amps., 120 volt, single phase operation with an on/off thermostat switch and pilot light. A 6’ long, 3-wire cord and plug (NEMA 5-15P) will be provided.
Casters: The casters shall be 4” diameter, non-marking rubber tired, swivel type with ball bearings in both swivel and axle raceways, provided with grease fittings. Both casters on operator’s side have toe activated brakes.
